Tile Adhesive

Product Details:

Latafix Floor and Wall Thin-set Adhesive 305

Additional Information:

• Delivery Time: 24 HOURS
• Packaging Details: Ideal for fixing ceramic tiles on floor Meets ANSI A 118.1 Economy Grade Smooth & Creamy A factory-made bagged cementitious polymer based powder, containing Portland cement and silica sand, it can be mixed with water for installing small and medium size ceramic floor tiles in interior areas using the thinset method of installation. For fixing cermic tiles on interior floor & wall Ideal for new floor tiling Economical & easy to use Single component - Just add water CoverageApprox. 55-60 sq. ft. per 20 kg bag with a ¼” x ¼” (6mmx6mm) square notch trowel for a bed of 3mm.ColorGreyCertification ANSI : Meets ANSI A 118.1 T EN 12004/ISO 13007: C1T IS 15477:2019 TYPE 1 T ADHESIVE VOC: Practically Nil Substrate:The surface to be covered with Ceramic tile shall be sound and confirm to good design, rigid, clean and free of dirt, oil, grease, curing compounds, form release agents or loose plaster and paint. For economy the surfaces should be level and true with in: Walls – 3mm in 2.5m Floors – 1.5mm in 1.0mSurface Preparation: If a plaster/leveling mortar bed is applied, ensure that it is cured for at least 7 days to achieve proper strength before application of tile adhesive for installation of tile Ensure the substrate is clean and free from impurities like dust, dirt, debris, oil, grease, curing agents, loose plaster etc Dampen the wall before application of thin set adhesive Clean the back of tile for any dust or coating Mixing:The products can be mixed by hand or slow speed electric drill mixer (less than 300 rpm). Pour potable clean water in a clean container and then add the powder LATAFIX® 305 and mix until the mixture becomes creamy and plastic. Do not over mix. Leave the mix to slake for 5-10 min and remix before use. Mix only sufficient quantity of adhesive for immediate need.Proportion:Approximately 1 bag of LATAFIX® 305 with 5-6 ltrs of water. Adjust quantity of liquid to obtain proper consistency.Installation: Wet the surface and remove the excess water b

Product Details:

Single component, just add water • Interior applications, polymer based • Economical & Easy to use • Bonds to various substrates • Exceeds ANSI A118.1 T shear bond strength requirements • Complies with EN / ISO with a C1T classification. • Exceeds IS 15477:2019 – Type 2 T Adhesive standards. • Can be fortified with latex admix for use on external Wall area. 

Additional Information:

• Delivery Time: 24 HOURS

Product Details:

• Easy to handle, economical and has multiple applications
• Increases water resistance under rubber-wheeled traffic
• Improved flexibility, low water cement ratio, resistance to water penetration
• Bonds strongly to concrete, plasters, masonry, cementitious surfaces
• • Reduces cracking through mortar flexural strength, reduces drying and aging shrinkage cracks

Product Details:

Ramco Dry Mix Division manufactures pre mixed dry mortars viz. plasters, wall putty and tile adhesive. These premixed dry mortars are manufactured under controlled conditions of selection and blending to suit specific application needs and has numerous advantages over jobsite mixes.

Product Details:

Ramco Dry Mix Division manufactures pre mixed dry mortars viz. plasters, wall putty and tile adhesive. These premixed dry mortars are manufactured under controlled conditions of selection and blending to suit specific application needs and has numerous advantages over jobsite mixes.

Additional Information:

• Packaging Details: Interior And Exterior Floor And Wall Installations